Flight Systems
Generator Controls spacer Engine Idle Limiter spacer About Us
RV Controls Highway, Marine & Industrial Controls


REPRESENTATIVES WANTED
Click here for more info



Model 277
User-Friendly Engine Idle Limiter

EPA Compliant, Saves Fuel!

Easy to Install!
Only 4 wires and you have options!

Click below for wiring diagrams
Basic | Advanced

engine idle limiter, engine idle timer, engine shutdown timer
  • Factory Direct: $169 free shipping
  • Specify 12 or 24 volts when ordering
  • Dealer discounts available
more info
buy now

Purpose

The Model 277 Engine Idle Limiter is designed to help save fuel and protect the environment by limiting the time that an engine is permitted to remain idling when the vehicle is parked. The installation of this unit will help to assure compliance with recent enacted laws regulating the allowable idle times of certain classes of vehicles.

NEW! Click here to see the fuel savings of a CAT 988 over 4 months before and after the installation of a Model 277 Engine Idle Limiter.

Click here to view an installation guide for CAT 323D L Excacators.

At a Glance

  • Complies with Region 1 EPA Mandatory Idle Limit and conforms to Federal Motor Carrier Safety Regulations 49.CFR.393
  • Compatible with ECM and non-ECM controlled engines
  • Complies with CAT SEPD0967 Mobile Earthmoving Equipment Automatic Engine Shutoff Systems safety recommendations
  • Optional 3 minute shutdown - Complies with DE, CT & DC Idling limits (Order Model 277-3)
  • Available with Mild Weather Option
  • Comes factory pre-set with 5 minute delay; 10 minute delay is user adjustable
  • Reduces RPM count by millions per year, extends engine life, stops fuel waste
  • Gas or diesel engines, 12v or 24v, manual or automatic transmission
  • Fast installation - 4 wires to connect
  • Accessory shutdown to save battery
  • 2 year warranty
  • Complies with California Air Resource Board (CARB) idle time limiting regulation
  • It gets even better! If you install an idle limiter you get a tax break as well. In the Energy Improvement and Extension Act (EIEA) of 2008, Section 206 excludes certain idling reduction devices from the federal excise tax. This law amends section 4053 of the Internal Revenue Code.
  • Inhibits shutdown during regeneration cycle
engine-idle-limiter-service-tool

Optional Equipment

Idle Limiter Service Tool

Fourteen LED indicators enable quick verification of vehicle wiring on new Idle Limiter installations and speed troubleshooting of existing installations. The Service Tool will indicate when the ignition is on, the voltage input is energized, power is applied to engine "run" and accessory circuits, and when the ECM STOP signal is energized. Also featured on the unit is the abillity to directly control the engine "run" and accessory circuits. Order part number 57-A277-08 ($89)

Mild Weather Option Kit

With this optional kit installed the Engine Idle Limiter will ONLY work when outside air temperature is between 'the comfort range' of +40°F (+5° C) and +80°F (+28° C). Other temperatures are available on special order. When the outside temperature is above or below this ‘comfort range’, the engine will idle as long as the operator desires while the vehicle is unattended to keep heaters & air conditioners operating in the cab. 57-A277-02 ($20)

CAT SEPD0967 Kit

For compliance with Caterpillar SEPD0967 which requires an indicator light and an exemption for operator-on-board situations we offer a low cost accessory kit that includes a red indicator light for time-out warning, and an operator-on-board inhibit switch along with installation instructions. Please order part number 57-A277-09 ($35).

3 Minute Shutdown Version

Available in either 12 or 24 volts, this version of the Engine Idle Limiter will shut engines down after 3 minutes of idling time. This complies with Delaware, Connecticut, and DC Idling limits. Order Model 277-3.

Fleet Idle Limiter

ATTENTION FLEET OWNERS: The Model 276 costs $98 each in lots of 10 and up only. This special fleet version is the same as the Model 277 in appearance, operation, and connection but does not have the accessory control and comes with a basic 4-wire harness. Also available in a 3 minute version as Model 276-3 at the same price. Please specify Model 276 and voltage when ordering.

How it Works

A countdown sequence is initiated when the parking brake (or other switch that is ground when engaged) is set OR command signal is received from "Park" position (switch closure to +). If the signal is removed before the time period expires the unit is reset and the engine is not shut down. The unit is connected to the Run, Fuel Pump, or Coil circuit on the engine or the ECM Stop input.

Emissions Laws

Emissions laws are becoming more strict concerning engine idling. California, New Jersey, Florida, Maryland, Pennsylvania, Massachusetts, and New York have passed legislation limiting the idle times of on-highway and off-highway commercial & industrial vehicles to no more than 5 minutes. Similar legislation pending in other states – visit Compendium of Idling Regulations (Updated July 2010) for an up to date list maintained by American Transportation Research Institute (ATRI). Install this low-cost Model 277 Engine Idle Limiter and avoid fines - plus save wear & tear, unnecessary emissions & wasted fuel. This cost-effective engine idle timer complies with these requirements.